Home > News > Yingyi Gear motor reducer-Usage & Installation

News

Yingyi Gear motor reducer-Usage & Installation
2013-07-15 09:25:07
 

Yingyi Gear motor reducer-Usage & Installation

CHECK BEFORE USAGE

alt

Check if the model, model NO., horse power, shaft direction, reduction ratio, revolution direction and input/output shaft revolutions are in accordance with the standard.

?

PLACE

alt

A flat and solid base is one of the requirements for installation.

alt

The environment for installation shall be dry and well ventilated, with ambient temperature at 0°C to 40°C .  Abnormal high or low temperature shall be dedicated.

?

CONNECTING METHOD

alt

The coupler shall be firmly connected the input and output shafts and two shafts shall be paralleled.  The base seat shall be anchored with proper bolts.

alt

All the components shall be properly assembled to the shaft.  Hammering and over-tight assembly which could damage the bearing are not allowed.

alt

The pulley, chain pulley and gear shall be assembled as close as possible to the gearing so as to reduce curving stress to the minimum.

alt

Chain pulley on top of output shaft should not be oversize.  Normally it is larger than output shaft 3~5 time.

alt

Grease of high quality is used on interior gear that avoids replacement or maintenance.

alt

When you equip the motor, please take the drawing on the motor as a reference to make sure of voltage.

?

MOTOR
alt The voltage variation over 10% could cause motor to burn out and reduce the torque of output shaft.
alt Motor is subject to damage due to overload.
alt Wrong wire connection could cause motor to burn out.
alt High-moisture environment could get the brake of motor rusted and disabled.
alt An appropriate motor shall be applied with the frequency converter while the low frequency is required in usual condition.

?

Installation Condition (for standard product)

?

alt

Ambient Temperature: -5ºC?40ºC

alt

Ambient Humidity: below 85%

alt

Ambient Condition: Please place in dry and well-ventilated location.  Environment with corrosive gas, inflammable gas and moisture should be avoided.

alt

Location: Indoor; the product should be installed on flat and solid foundation.

alt

Elevation: below 1000m


Previous   [Return Home] [Print] [Go Back]   Next

Contact Us

  • Tel:

    008613760859053...............(Mob / whatsapp:)
  • Contact: Mr.Leo Zhang
  • Fax:

    008675786698261
  • E-mail:

    sales@yygear.com
?????????